Browsing by Author "Ustaoğlu A."

Now showing 1 - 2 of 2

Development, characterization, and performance analysis of shape-stabilized phase change material included-geopolymer for passive thermal management of buildings
(2022-12-01) Gencel O.; Harja M.; Sarı A.; Hekimoğlu G.; Ustaoğlu A.; Sutcu M.; Erdogmus E.; Kaplan G.; Bayraktar O.Y.
The cooperation between phase change materials (PCMs) and geopolymer (GP) is energy-efficient way for improving the thermal performance of construction materials. This study discusses the effect of PCM combination with GP matrix on obtained concretes' mechanical and thermal properties. Attapulgite/lauric-capric acid eutectic mixture (ATP/LCEM) composite was fabricated as shape-stable composite phase change material (SSPCM) and then integrated with GP concrete (GPC) for improvement of the thermal mass of buildings. Thermal, mechanical, physical, morphological, thermal energy storage (TES) characteristics, and solar thermoregulation performances of the developed GPC-SSPCMs were experimentally characterized. The compressive strength was found over 6 MPa for GPC without aggregates (only SSPCM). The compressive and flexural strengths were relatively low, but above the requirements of the current standards. Other properties as thermal conductivity and solar performance make the produced GPC-SSPCMs promising materials for advanced TES applications in buildings. The apparent porosity was around 45% for GPC-SSPCM-50 and 63% for GPC-SSPCM-100, while water adsorption around 21% for GPC-SSPCM-50 and 30% for GPC-SSPCM-100. Thermal conductivity values of 0.375 W/mK for GPC without aggregates recommended this material as an insulator. The produced SSPCM composite melts at 19.00°C with corresponding latent heat of 73.9 J/g, while the GPC-SSPCM melts at 18.30°C with corresponding latent heat of 6.57 J/g. Based on the obtained outcomes, the energy-saving was determined as 5.56 kWh, which is corresponding to the CO2 saving of 15 kg-CO2, 14.68 kg-CO2, and 2.41 kg-CO2 in case of using coal, natural gas, or electricity, respectively as energy source.
Foam Concrete Produced with Recycled Concrete Powder and Phase Change Materials
(2022-06-01) Gencel O.; Nodehi M.; Hekimoğlu G.; Ustaoğlu A.; Sarı A.; Kaplan G.; Bayraktar O.Y.; Sutcu M.; Ozbakkaloglu T.
In construction industry, phase change materials (PCMs), have recently been studied and found effective in increasing energy efficiency of buildings through their high capacity to store thermal energy. In this study, a combination of Capric (CA)-Palmitic acid (PA) with optimum mass ratio of 85–15% is used and impregnated with recycled concrete powder (RCP). The resulting composite is produced as foam concrete and tested for a series of physico-mechanical, thermal and microstructural properties. The results show that recycled concrete powder can host PCMs without leaking if used in proper quantity. Further, the differential scanning calorimetry (DSC) results show that the produced RCP/CA-PA composites have a latent heat capacity of 34.1 and 33.5 J/g in liquid and solid phases, respectively, which is found to remain stable even after 300 phase changing cycles. In this regard, the indoor temperature performance of the rooms supplied with composite foams made with PCMs, showed significantly enhanced efficiency. In addition, it is shown that inclusion of PCMs in foam concrete can significantly reduce porosity and pore connectivity, resulting in enhanced mechanical properties. The results are found promising and point to the suitability of using RCP-impregnated PCMs in foam composites to enhance thermo-regulative performance of buildings. On this basis, the use of PCMs for enhanced thermal properties of buildings are recommended, especially to be used in conjunction with foam concrete.